To get a fiber optic signal to your router, you need an Optical Network Terminal (ONT) to convert the fiber's light signal into an electrical signal, which is then connected to your router via Ethernet.

Step 1: Gather the Necessary Equipment

• Optical Network Terminal (ONT): Provided by your ISP, this device converts incoming fiber light signals into electrical signals your router can use .
• Fiber optic cable: Usually single-mode with SC/APC or SC/UPC connectors .
• Router: Ensure it has a WAN or SFP port compatible with Ethernet input from the ONT .
• Ethernet cable: Typically Cat6 or higher to maintain high-speed data transfer .

Step 2: Install the ONT

1. Locate the fiber optic wall outlet where the ISP's fiber line enters your home.
2. Connect the fiber optic cable to the ONT's optical input port, handling the connector carefully to avoid dirt or damage .
3. Power on the ONT and wait for the status lights to stabilize, indicating a successful connection to the ISP network .

Step 3: Connect the ONT to Your Router

1. Use an Ethernet cable to connect the ONT's LAN or Ethernet output port to the router's WAN port .
2. Power on the router and wait for the indicator lights to confirm a successful connection.

Step 4: Configure and Verify

• Most routers automatically detect the connection, but you may need to access the router's settings via a web browser for manual configuration using your ISP's instructions .
• Check the ONT and router lights: a solid green power light on the ONT indicates proper operation, and the router's WAN light should confirm internet connectivity .

Additional Tips

• Place the ONT and router in a dry, ventilated area near power outlets, ideally with surge protection .
• Avoid bending or stressing the fiber cable, as it is sensitive to damage .
• For larger homes, consider mesh Wi-Fi devices to extend coverage . By following these steps, the fiber optic signal is properly converted and delivered to your router, enabling high-speed internet access throughout your home.