We propose a flow meter that, unlike turbine or pressure-based sensors, is not flow intrusive, requires zero maintenance, has low risk of clogging, and is compatible with harsh conditions. Using optical fiber sensing, we monitor the temperature distribution along a fluid conduit. Pulsed heat. The method is experimentally validated for water and ethanol using optical frequency-domain reflectometry (OFDR) with millimetric spatial resolution over a 1.
[pdf] Optical fibers can be used as sensors to measure, , and other quantities by modifying a fiber so that the quantity to be measured modulates the,,, or transit time of light in the fiber. Sensors that vary the intensity of light are the simplest, since only a simple source and detector are required. A particularly useful feature of intrinsic fiber-optic sensors is that they can, if required, provide distributed sensing over very large distances.
[pdf] Stripping is the act of removing the protective polymer coating around optical fiber in preparation for fusion splicing. The splicing process begins by preparing both fiber ends for fusion, which requires that all protective coating is removed or stripped from the ends of each. Fiber strippers are precision tools that reliably and cleanly remove a defined length of coating (often 30–40 mm) from a fiber end so that the bare glass is exposed without scratching or nicking it. Mechanical fiber strippers for Large Diameter Fibers (LDF) for removing various coating materials from windows and fiber ends. Without question, good stripping techniques in your fiber. Laser stripping from OpTek Systems provides controllable and reproducible removal of acrylate or polyimide buffers with tight control over the position, location, and fiber-strength.
[pdf] To improve the safety and efficiency performance of partial discharge detection in a high-voltage direct current (HVDC) cable system, an optical fiber ultrasonic detection system for partial discharge is carried o.
[pdf] Quick answer: Strip the fiber jacket and buffer, clean the bare glass with 99% IPA, cleave to under 1 degree, load both fibers into the splicer, run the splice cycle, heat-shrink the protection sleeve, and verify the splice loss. Total time per splice for an experienced tech is. Firstly, it is important to consider that when stripping multi-layer cables for connectorization, each layer must usually be stripped individually, as they all usually need to be stripped to different lengths. Various techniques can remove the coating: Regardless of the method used to strip the coating, it is important to use the correct tools and techniques to prevent damage to the bare glass. The procedure is straightforward but unforgiving -- skip a step or get sloppy with prep, and the splice fails.
[pdf] 
