Quick answer: Strip the fiber jacket and buffer, clean the bare glass with 99% IPA, cleave to under 1 degree, load both fibers into the splicer, run the splice cycle, heat-shrink the protection sleeve, and verify the splice loss. Total time per splice for an. Without question, good stripping techniques in your fiber optic cable assembly process are imperative. What happens if you damage the fiber during this production step? A tiny scratch or nick in the optical fiber is like a time bomb. Mechanical splices are faster for emergency restoration but have higher typical loss (0. 1dB for fusion) and degrade over time in outdoor environments. It involves a series of carefully executed steps, each critical to ensuring a low-loss, high-quality splice.
[pdf] Stripping is the act of removing the protective polymer coating around optical fiber in preparation for fusion splicing. The splicing process begins by preparing both fiber ends for fusion, which requires that all protective coating is removed or stripped from the ends of each. Fiber strippers are precision tools that reliably and cleanly remove a defined length of coating (often 30–40 mm) from a fiber end so that the bare glass is exposed without scratching or nicking it. Mechanical fiber strippers for Large Diameter Fibers (LDF) for removing various coating materials from windows and fiber ends. Without question, good stripping techniques in your fiber. Laser stripping from OpTek Systems provides controllable and reproducible removal of acrylate or polyimide buffers with tight control over the position, location, and fiber-strength.
[pdf] The FOCC fully automatic optical cable stripping machine uses electrical control and is designed to automatically strip the 900-micron tight cladding and 250-micron coating of single-core and dual-core optical fibers. It supports the processing of up to 7 cores of fiber cable. 1-10mm² single wire and 7.
[pdf] 
